M90 setup (topend swap) or parts.

Posted: Wed Feb 14, 2007 3:21 pm Post subject: M90 setup (topend swap) or parts.

Baby on the way. I was going to m90 an l36 again, but lost intrest. I have everything you need to do it less the pcm(have yours flashed for a gtp, and the two harnesses for the map sensor and the boost bypass valve_ i can cut the wires out of the harness but might be cleaner if you just ordered the kit from zzp or intense, one of them has it for like 30.00)

M90 blower (ported lightly) with 3.25 pulley on snout, and a snout with a 3.8, lmk
Lowerintake (ported)
Ported manis(pems)
throttle body and thrasher nos spacer
all pulleys and brackets
Harmonic balancer
Fuel injectors and rail
And the heads,~ the heads have had some work done to them to support the 3.25 pulley, vavles have been ground open for more flow and a mild port job, springs been upgraded to 105's and modded retainers with new locks. I also have new valve seals installed too, no miles on the seals.

Looking to get best offer on a complete kit or will part out. also willing to trade
Looking for Dp, rockers mufflers... hv3 (l36)

Posted: Fri Feb 16, 2007 8:30 am Post subject:

	Upstate New York Club Grand Prix Forum Index -> Classifieds	All times are GMT - 5 Hours
Page 1 of 1