| View previous topic :: View next topic |
| Author |
Message |
Ace Total posts: 195
Andy2001 Regal GS Joined: 04 Aug 2006 Location: Rochester Age: 16 |
 Posted: Sun Oct 19, 2008 7:30 pm Post subject: LS1 TB, 3.4 pulley, ported Gen III |
 |
|
Gen III : Inlet has about 30 hours of dremel time and has been machined to 75mm. The outlet was LIM matched with the usual work done. $140 for the casing, if you need guts and snout PM me.
LS1 Throttle Body with Adaptor plate and 85mm MAF(not pictured). Adaptor plate has N2O jet option as well. $110
Stock 99 TB with MAF $40.
Thanks,
Andy
_________________
01 regal GS - 13.3 @ 105 2.2 60''
Last edited by Ace on Fri Nov 28, 2008 6:22 pm; edited 1 time in total |
|
| Back to top |
|
 |
| Ace Total posts: 195
Andy2001 Regal GS Joined: 04 Aug 2006 Location: Rochester Age: 16 |
| Posted: Sat Oct 25, 2008 7:44 pm Post subject: |
|
|
| bumpz |
|
| Back to top |
|
|
| studderin Total posts: 6272
John Csotello1998 Grand Prix GTP Joined: 01 Oct 2003 Location: 2nd gear burnouts Age: 43 |
| Posted: Sat Oct 25, 2008 9:43 pm Post subject: |
|
|
you had nozzz?
_________________
New Era performance
01z28, M6 NA, mullet, T tops, siqqqq |
|
| Back to top |
|
|
| Ace Total posts: 195
Andy2001 Regal GS Joined: 04 Aug 2006 Location: Rochester Age: 16 |
| Posted: Fri Nov 28, 2008 6:22 pm Post subject: |
|
|
| studderin wrote: | | you had nozzz? |
until i blowed the welds on the intake 
ttt |
|
| Back to top |
|
|
|
Album
Calendar
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages 
Log in