FS: Fbody Subframe connectors

Posted: Mon Jan 12, 2009 1:47 am Post subject: FS: Fbody Subframe connectors

Brand new, never used. BMR tubular weld in subframe connectors. Powder coated black hammertone

but in this color
http://www.bmrfabrication.com/sfc/SFC001H.jpg

Reduce chassis flex to a minimum and increase your handling capabilities with a set of BMR subframe connectors. These weld-in subframe connectors fit 1993-2002 F-bodies and will work with all aftermarket exhaust systems. All mounting plates are made from either 3/16" or 1/4" laser cut plates for the ultimate in strength. Boxed connectors use 2" square tubing while tubular connectors use 1-5/8" roll cage tubing. Which one do I choose? - While you can't go wrong with either design, use the following to determine your order: If strength is your number one priority, choose the boxed design. Boxed tubing is torsionally stronger than round tubing however you will lose approximately 3/4" of ground clearance when using this style. If your car is lowered and ground clearance is the prime concern, go with the tubular model. While round tubing is not as strong torsionally, there are other features to these subframe connectors that make them more rigid than most other tubular models available.

$125 picked up
_________________
New Era performance

01z28, M6 NA, mullet, T tops, siqqqq

Posted: Mon Jan 12, 2009 5:34 am Post subject:

Black hammertime?
_________________
Hi, I'm Matt.

I'm the resident smartass and I have fourblack children: (ok, one's only half black..)
07.5 2500HD, Duramax, Edge Race Evo CTS, MBRP 5" Stainless, TransGo, Sleeves, EGR!, PCV
09 VRSCDX - Night Rod. Flat black, gloss black
02 Black Z06. All work done by New Era Perforamnce. 519/497 at the rear, 3100 lbs.
05 Arctic Cat Firecat F7 - Sold
07 Arctic Cat F8 Sno Pro - Smashed into 1000 orange pieces.

	Upstate New York Club Grand Prix Forum Index -> Classifieds	All times are GMT - 5 Hours
Page 1 of 1