need an 02sensor code deleted

Posted: Sat Jun 06, 2009 1:55 pm Post subject: need an 02sensor code deleted

ohk so i just bought a 3in d.p used off another grand prix forum. it doesnt have a cat so i know its going to throw a code, i dont have any other mods yet so i dont wana get a tune for my pcm untill i get my pully and a few other mods. can anyone delete this code for me on my stock pcm or should i just drive with the light on for now until i get my other mods and get the full tune?

Posted: Sat Jun 06, 2009 2:59 pm Post subject:

Are you coming to the picnic?

Posted: Sat Jun 06, 2009 4:29 pm Post subject:

idk yet, if i can get off work then yes.

Posted: Sun Jun 07, 2009 9:18 am Post subject:

i have a tuner here and can shut it down if ya wanted.. just have to make the drive to here..... Evans/angola.

Posted: Sun Jun 07, 2009 9:38 am Post subject:

how was it to change the DP?
_________________
New Era performance

01z28, M6 NA, mullet, T tops, siqqqq

Posted: Sun Jun 07, 2009 4:32 pm Post subject:

Posted: Sun Jun 07, 2009 5:39 pm Post subject:

If the bolts arn't rusted too bad it shouldnt be too hard at all......just heat em up a tad and they should break rite loose. Back when I used to have the 3'' DP b4 i did headers, it took me like 20 minutes to install, my car had never seen winter tho....so the bolts came off with literally almost no effort.
_________________

-2000 Grand Prix GTP silvermist
-2003 Grand Prix GT redfire metallic
-1991 Grand Prix GTP LQ1/Getrag284 5 speed. Neon blue metallic.
-1999 Regal GSE....SOLD.

Posted: Mon Jun 08, 2009 12:39 am Post subject:

his car is super clean, they will come right off.

Posted: Mon Jun 15, 2009 8:41 pm Post subject:

loudgp are you still willing to delete that code for me? i just got the dp in today and don't wana throw it on till i can either get it deleted first or very soon after its on cuz im prolly going to run either lean/rich while its on and don't wana burn up my plugs just yet.

Posted: Tue Jun 16, 2009 5:51 am Post subject:

hopefully it's not like the wifes Regal that was a major pain in the balls. Her car is driven year round so it gets all the fun weather Rochester has to offer. HEAT is your friend, i'd say start hitting them with some PB a few days before you go at it so they're soaked.

Posted: Tue Jun 16, 2009 6:23 am Post subject:

Posted: Tue Jun 16, 2009 3:25 pm Post subject:

Posted: Tue Jun 16, 2009 9:32 pm Post subject:

poooor car

Posted: Mon Jun 22, 2009 4:56 pm Post subject:

ohk so im doing my d.p tommorow and was just wondering if i get the rear 02sensor code deleted then go to run my car through for an inspection will it pass cuz the code isnt there? I know the light wont be on but will the computer to hook up for inspection realize that that monitor isnt working and not there and fail the car?

Posted: Tue Jun 23, 2009 6:58 am Post subject:

You won't know for sure until you try it. If you have a problem, it will be the readiness monitors. If you reset the computer, the readiness monitors have to run. This is why they tell you to drive a bit before they test the car. But with older cars, some of the readiness monitors are allowed to fail. Depending on how old the car is, a certain number can fail and you can still pass.

If that turns out to be a problem, it's possible to use the PCM programmer to make the monitors ready for inspection. You set every DTC to 'not reporting' before inspection. Then program it back to normal when you are done.

	Upstate New York Club Grand Prix Forum Index -> PCM / Tuning	All times are GMT - 5 Hours Goto page 1, 2 Next
Page 1 of 2