L67 FOR SALE

Posted: Fri Feb 16, 2007 11:58 am Post subject: L67 FOR SALE

L67 with 158k miles on it, runs good, dented oil pan. Comes with M90 Super Charger, 1:9 first gen rockers(installed), stock injectors, Throttle body, etc.. May have some small brackets removed, No AC compressor,alt. This is a basically complete motor, not a long block. PM me with ?s. Offers start at 300
_________________
2001 Silver GTP coup 11.880@116.17 Fun Driver
1998 SilverMyst GTP sedan 13.716 Sold
2010 Black Camaro Daily Driver
1969 Firebird convertible 455 FUN

Posted: Fri Feb 16, 2007 1:41 pm Post subject:

Any interest in selling just the rockers?

Posted: Fri Feb 16, 2007 1:42 pm Post subject:

doug if u do decide to sell the rockers, lemme know, ill give u $150 shipped..
_________________
MODS: Stock

Posted: Sat Feb 17, 2007 8:51 am Post subject:

I may part it out if I can't sell it complete. $300 , come get it!! Was running strong when pulled (strong enough to break my stock flex plate in 2 pieces)

Posted: Sat Feb 17, 2007 11:44 am Post subject:

Put me in line first for the rockers if you demod, since i did beat junior buy 1 minute Very Happy

Posted: Sat Feb 17, 2007 10:30 pm Post subject:

wish i didn't just pickup a 94 L67. I would have bought this one. Maybe if I can sell my 71 buick 350 motor. interested in a possible partial trade?

Posted: Wed Feb 21, 2007 1:10 am Post subject:

the pizza is delivered
_________________
New Era performance

01z28, M6 NA, mullet, T tops, siqqqq

Posted: Wed May 09, 2007 8:37 am Post subject:

To all those asking about the 1st gen 1:9 rockers in this motor, I would like to sell the whole motor. It runs very strong right now, good for a GT swap, move up to a L67. This motor ran 13.7 with poor tune and a bad 60' on big street tires.
I would replace oil pan gasket as it has a small leak, and pop the dent out of oil pan at that time, easy and no big deal when the motor is out of car.
But if I were going to put it in a set up that was planned to make a lot more HP, like 300+ WHP turbo, I would just replace crank and rod bearings with std. size ones while the oil pan is off.
Matt, you have a PM.
Doug

Posted: Sat May 12, 2007 2:17 pm Post subject:

SOLD. I think Matt will be selling the 1st gen rockers that are in it here on the forums classified section very soon. So for those that wanted them, watch for his post. Thanks to all that asked.

	Upstate New York Club Grand Prix Forum Index -> Classifieds	All times are GMT - 5 Hours
Page 1 of 1