WTB engine

Posted: Tue Nov 10, 2009 4:50 pm Post subject: WTB engine

Anyone have a good 3800, NA or supercharger. Might need a shortblock soon, just seeing what out there local.
_________________
New Era performance

01z28, M6 NA, mullet, T tops, siqqqq

Posted: Tue Nov 10, 2009 6:22 pm Post subject:

i have one. i guess it would be useable if you were doing a full rebuild. you pull it, you can have it. same with the trans

Posted: Tue Nov 10, 2009 6:55 pm Post subject:

I'll pass

Posted: Tue Nov 10, 2009 7:32 pm Post subject:

Sams engine

BTW i dont blame you for passing

Posted: Tue Nov 10, 2009 7:47 pm Post subject:

thanks corey i have a 04 l32 block with no LIM or UIM with 83k i can work a deal out with you if you want
_________________
2001 Grand Prix GTP - Intake, Borla Catback, Tune
2004 Regal GSX - Turbo, I/C 11.46 @ 122.8mph
http://www.youtube.com/watch?v=j5IqjNkscds

Posted: Tue Nov 10, 2009 8:13 pm Post subject:

if u buy Sams, i can throw in Top swap. i have bolt L32 and L67. or even L36 for Turbo build Twisted Evil

Posted: Tue Nov 10, 2009 8:45 pm Post subject:

ok, Not looking to rebuild anything. A good running shortblock.

Posted: Tue Nov 10, 2009 9:54 pm Post subject:

I might have a rebuilt L36 in a few weeks when I get mine out and the new engine in.

Posted: Wed Nov 11, 2009 12:18 pm Post subject:

it doesnt need to be rebuilt or anything, it just needs a Lower Intake Manifold and Upper intake manifold and valve covers

Posted: Wed Nov 11, 2009 2:58 pm Post subject:

The one in my car im pulling might have a bad rod bearing, its torn down right now and i couldnt find anything wrong with the lifters or push rods soo im thinkin its a rod bearing. i just bought a 3.8 supercharged engine for 200 today that im swappin in my car.

Posted: Wed Nov 11, 2009 7:43 pm Post subject:

I've got a short block with a bad rod bearing in my garage
_________________
70 Monte Carlo 12.5@109 frame off in progress...

Posted: Wed Nov 11, 2009 8:27 pm Post subject:

I'm takin it out on sunday, ill let you know if its got a bad rod bearing or not. if its not, ill let the engine go for cheap.

Posted: Wed Nov 11, 2009 8:39 pm Post subject:

I do not need a engine with a bad rod bearing Laughing

Posted: Thu Nov 12, 2009 12:41 am Post subject:

Posted: Thu Nov 12, 2009 10:30 am Post subject:

I have a short block, I even have a new timing set that could go with it too. I'll have to look for the front cover as well. It's all there in the garage somewhere but the short bloack was never touched. I bought it as a spare because you can never only have one of anything. The heads need to be cleaned up if you wanted those too. Let me know you can come by and take a look at it.

	Upstate New York Club Grand Prix Forum Index -> Classifieds	All times are GMT - 5 Hours
Page 1 of 1